Last Modified: 11-29-2007 1.6 A
Service Category: Power Source/Network Section: Battery/Charging
Model Year: 2008 Model: Sequoia Doc ID: RM000002BS200PX
Title: 2UZ-FE BATTERY / CHARGING: GENERATOR: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL GENERATOR ASSEMBLY

(a) Install the generator assembly with the bolt and 2 nuts.

  • for bolt and nut (A)

Torque: 39 N·m (398 kgf·cm, 29 ft·lbf)

  • for nut (B)

Torque: 16 N·m (163 kgf·cm, 12 ft·lbf)


(b) Connect the generator connector.

(c) Connect the generator wire with the nut.

Torque: 9.8 N·m (100 kgf·cm, 87 in·lbf)

(d) Install the terminal cap.

(e) Install the harness bracket to the generator assembly with the bolt.

Torque: 8.2 N·m (84 kgf·cm, 73 in·lbf)

2. INSTALL VANE PUMP ASSEMBLY 2UZ-FE ENGINE MECHANICAL: TIMING BELT: INSTALLATION (2008 Sequoia)+

3. INSTALL FAN AND GENERATOR V BELT 2UZ-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION (2008 Sequoia)+

4. INSTALL AIR CLEANER HOSE ASSEMBLY 2UZ-FE ENGINE CONTROL: THROTTLE BODY: INSTALLATION (2008 Sequoia)+

5. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY 2UZ-FE ENGINE CONTROL: THROTTLE BODY: INSTALLATION (2008 Sequoia)+

6. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 2UZ-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 Sequoia)+

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 Sequoia) .